SUNLU Wood Filled Filament

• Authentic Wood Appearance: Prints with a genuine wood-like grain and a matte finish that can vary in shade depending on the wood type and finishing.
• Easy to Print (PLA Base): Most wood-filled filaments are based on PLA, making them relatively easy to print on a wide range of desktop FDM 3D printers. They generally require similar printing temperatures to standard PLA.
• Lightweight: The wood particles can make prints slightly lighter than solid plastic equivalents.

• There are two WOOD filament recommended print temperatures, please check the package label before you start printing.
• Nozzle Size: It is highly recommended to use a 0.4mm nozzle or larger to prevent clogging, as the wood particles can sometimes jam smaller nozzles. A 0.6mm nozzle is often preferred for a smoother experience.
• Nozzle Wear: Over time, the abrasive nature of wood particles may cause increased wear on standard brass nozzles. Consider using a hardened steel or wear-resistant nozzle for extended use.
• Lower Print Speeds: Printing at slightly slower speeds (e.g., 30-50mm/s) can help achieve better layer adhesion and prevent clogs.
• Heat & Over-Extrusion: Printing too hot or with excessive flow can lead to burning of the wood particles, resulting in darker spots or charred appearances. Adjust temperature and flow settings carefully.

• Print Temp: 190-220℃
• Low print Temp: 170-190℃
• Print Speed： 50-100mm/s
• Platform Temp： Depends on the platform: No need or 60-80℃
• Tensile Strength： 8-13kgf
• Melt Flow Rate： 8-13g/10min(190℃,2.16kg)
• Tolerance： ±0.02mm
• N.W.： 1kg

The above settings are general guidelines. The exact optimal settings can vary slightly depending on your specific 3D printer model, the brand of filament, and even environmental factors like room temperature. Always refer to any specific recommendations provided by the filament manufacturer on the spool or packaging.